Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 97)

-97-
4.2.48.48 lldp receive
Command:
lldp receive
lldp
LLDP configurations
receive
Enab le/Disable decoding of received LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Rx only mode for specific interface
Example:
To configure LLDP Rx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp receive
4.2.48.49 lldp tlv-select management-address
Command:
lldp tlv-select management-address
lldp
LLDP configurations
tlv-select
To transmit which optional TLVs.
management-address
Enable/Disable transmission of management address.
Default:
Enabled
Usage Guide:
To enable management address of LLDP TLV for specific interface
Example:
To enable management address of LLDP TLV for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp tlv-select management-address