Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 85)

-85-
4.2.48.25 gvrp leave-request vlan(GG)
Command:
gvrp leave-request vlan <vlan_list>
gvrp Enable GVRP on port(s)
leave-request
Emit a Leave-Request for test purpose
Default:
N/A
Usage Guide:
To send GVRP Leave-Request to specific interface
Example:
To send GVRP Leave-Request(VLAN 1) to GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # gvrp leave-request vlan 1
4.2.48.26 ip arp inspection check-vlan
Command:
ip arp inspection check-vlan
arp Address Resolution Protocol
inspection
ARP inspection
check-vlan
ARP inspection VLAN mode config
Default:
Disable
Usage Guide:
To configure Check-VLAN mode into ARP inspection for specific interface
Example:
To configure Check-VLAN mode (Enabled) into ARP inspection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X