Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 109)

-109-
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck action alarm
4.2.48.71 poe pdcheck enable
Command:
poe pdcheck enable
poe
Power Over Ethernet.
pdcheck
Allows user to enable or disable per port PD Alive Check function.
enable
PD alive check enable.
Default:
Disabled
Usage Guide:
To enable PD Ping Alive Check function of PoE for specific interface.
Example:
To enable PD Ping Alive Check function of PoE for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck enable
4.2.48.72 poe pdcheck interval
Command:
poe pdcheck interval <10-300>
poe
Power Over Ethernet.
pdcheck
Allows user to enable or disable per port PD Alive Check function.
interval
set how long system should be issue a ping request to PD for detecting whether PD is
alive or dead.
<10-300>
interval <10~300>
Default:
30