Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 165)

-165-
Switch# configure terminal
Switch (config)# ip arp inspection entry interface GigabitEthernet 1/1 1
00:11:22:33:44:55 192.168.0.18
4.2.52 ip arp inspection translate
Command:
ip arp inspection translate
ip Internet Protocol
arp
Address Resolution Protocol
inspection
ARP inspection
translate
arp inspection translate all entries
Default:
N/A
Usage Guide:
To translate dynamic entries into static ARP inspection table.
Example:
To translate dynamic entries into static ARP inspection table.
Switch# configure terminal
Switch (config)# ip arp inspection translate
ARP Inspection:
T ranslate 1 dynamic entries into static entries.
4.2.53 ip arp inspection translate interface
Command:
ip arp inspection translate interface [10GigabitEthernet | GigabitEthernet] <vlan_id>
<mac_ucast> <ipv4_ucast>