112 spanning-tree mst <instance : 0-7> cost, 113 spanning-tree mst <instance : 0-7> cost – Interlogix NS3702-24P-4S Command Line Guide User Manual
Page 132
-132-
Switch (config-if) # spanning-tree edge
4.2.48.112 spanning-tree mst <Instance : 0-7> cost
Command:
spanning-tree mst <Instance : 0-7> cost <Cost : 1-200000000> | auto
spanning-tree
Spanning Tree protocol
mst
ST
P bridge instance
<Instance : 0-7>
instance 0-7 (CIST=0, MST2=1...)
cost
STP Cost of this port
<Cost : 1-200000000>
Cost range
auto
Use auto cost
Default:
Auto
Usage Guide:
To configure Path Cost of CIST / MST Normal Port Configuration for specific interface
Example:
To enable Path Cost (100) of CIST / MST Normal Port Configuration (CIST) for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree mst 0 cost 100
4.2.48.113 spanning-tree mst <Instance : 0-7> cost
Command:
spanning-tree mst <Instance : 0-7> port-priority <Prio : 0-240>
spanning-tree
Spanning Tree protocol
mst
ST
P bridge instance
<Instance : 0-7>
instance 0-7 (CIST=0, MST2=1...)
port-priority
STP priority of this port
<Prio : 0-240>
Range (lower higher priority)
auto
Use auto cost