Interlogix NS3702-24P-4S Command Line Guide - Manual (Page 106)

-106-
network-clock
network-clock
synchronization
SSM enable/disable.
ssm
SSM enable/disable.
Default:
Disable
Usage Guide:
To enable SSM of SyncE for specific interface
Example:
To enable SSM of SyncE for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # network-clock synchronization ssm
4.2.48.66 no
Command:
no
no
Negate a command or set its defaults
Default:
N/A
Usage Guide:
To default the function for specific interface
Example:
To enable the function (network-clock synchronization ssm) for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # no network-clock synchronization ssm
4.2.48.67 ping ip
Command:
ping ip <ipv4_addr> size <size: 2-1452>