8 access-list shutdown, 9 aggregation group – Interlogix NS3702-24P-4S Command Line Guide User Manual
Page 76
-76-
Disable
Usage Guide:
To redirect frames to specific Port.
Example:
To redirect GigabitEthernet X/X frames to GigabitEthernet 1/2.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list redirect interface GigabitEthernet 1/2
4.2.48.8 access-list shutdown
Command:
access-list shutdown
shutdown Shut down incoming port. The shutdown feature only works when the packet length is less than 15 18
(without VLAN tags).
Default:
Disable
Usage Guide:
To enable Shutdown function for the ACL.
Example:
To enable ACL Shutdown function for the GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # access-list shutdown
4.2.48.9 aggregation group
Command:
aggregation group <uint>
aggregation
Create an aggregation
group
Create an aggregation group
<uint>
The aggregation group id
Default: