User-defined pushbuttons (sw2 through sw5) – Altera Cyclone II DSP Development Board User Manual
Page 20
2–12
Reference Manual
Altera Corporation
Cyclone II DSP Development Board
August 2006
User Interfaces
User-Defined Pushbuttons (SW2 Through SW5)
SW2-SW5 are user-defined momentary-contact push-button switches
used to provide stimulus to a user design on the Cyclone II DSP
development board. Each push-button is connected to the EP2C70
general-purpose I/O pin as listed in
. When the switch is
pressed and held down, the device pin is set to logic 0, when the switch
is released, the device pin is set to logic 1.
shows the
push-buttons.
Figure 2–5. User-Defined Pushbuttons
Table 2–5. User-Defined Push-Button Pin-Outs
Push-Button
Name
Board Reference
Schematic Signal
Name
Cyclone II (U12)
Pin Number
PB3
SW2
USER_PB3
AE14
PB2
SW3
USER_PB2
AE22
PB1
SW4
USER_PB1
AE16
PB0
SW5
USER_PB0
AC18
SW2
PB3
SW3
PB2
SW4
PB1
SW5
PB0