CIRCUTOR CVM-B Series - Manual (Page 153)

Output 1, to select the configuration of the digital output of transistor 1.
Output 2, to select the configuration of the digital output of transistor 2.
Back, returns to the home screen of the setup menu figure 113 .
Main Menu, back to the main menu, figure 25 .
Use the keys and to select the different options.
To confirm the selection, press the key .
If no key is pressed for 5 minutes, the display screen changes automatically to the default
screen, which displays the voltage measurement of 4 parameters.
After selecting the output to configure, you can configure the transistor output mode, Alarm or
Impulse output, and the parameters for each mode.
Alarm, to select the alarm mode of the transistor digital output.
Impulses, to select the impulse mode of the transistor digital output.
5�6�16�1�- Alarm mode of transistor digital output
When selecting the alarm mode, figure 131, the configuration parameters are:
 The variable code that controls the transistor.
 The pre-alarm value.
 The minimum value below which the transistor is activated.
 The maximum value above which the transistor is activated.
 The delay in the connection and disconnection of the transistor.
 The status of the outputs.
 The latch.
figure 131: Configuration screen of transistor digital outputs (alarm mode).
153 Instruction Manual
CVM-B100 - CVM-B150