CIRCUTOR CVM-B Series User Manual
Page 211
Advertising
B- Protective cove version 2
To install, firstly remove the protective cover of the expansion connector located at the rear of
the unit. To do so:
a�- Remove the two fastening pins that secure the protective cover with a flat tip screwdriver,
Protective cover
figure 145: Remove the two fastening pins�
b�- Remove the protective cover by inserting a flat tip screwdriver into the fixing slot and press
the cover upwards.
(
figure 146: Remove the protective cover�
Connect the expansion module to the unit,
.
figure 147: Connect the expansion module�
211
Instruction Manual
CVM-B100 - CVM-B150
Advertising