AGI Security GV-CONCT - Manual (Page 41)

GV-AS110 Controller
31
2
2.3.1.A Adding a Card
Up to 1,000 cards can be enrolled on GV-AS110 directly without needing additional software.
When working with GV-ASManager software, GV-AS110 can support up to 40,000 cards.
1. Present the Enroll Card.
2. Enter a 4-digit PIN code for the new card, reenter the same 4-digit PIN code and then
enter the command code for a desired type of card listed below. The LED will blink green
and red for about 10 seconds. You must finish entering the PIN code twice and the card
command code within the 10 seconds.
Code Types of Cards Description
0 Normal Card The door unlocks after a card is presented. Normal
Cards will not be granted access when Two Person
Entrance/Exit or Security Mode is enabled.
1 Two-person A Card In the Two Person Entrance/Exit mode, the door
unlocks only when two-person B card is also
presented together.
2 Two-person B Card In the Two Person Entrance/Exit mode, the door
unlocks only when two-person A card is also
presented together.
3 Security Card The Security Card is used for launching the Security
Mode, in which no cards can be granted access and
no one can program the unit. Only the Security Card
will be able to disable the Security Mode.
3. Present the card you want to add to the GV-AS110.
4. The GV-AS110 will produce a long beep if the card has been added successfully and
three short beeps if the adding procedure has failed.
If you do not want to customize a password, you can simply present the Enroll Card and
then present the card you would like to add. The default password will be 1234 and the card
will automatically be set to a Normal Card.
2.3.1.B Deleting a Card
1. Present the Delete Card.
2. Present the card you want to delete.
3. The GV-AS110 will produce a long beep if the card has been deleted successfully and
three short beeps if the deleting procedure has failed.