Orion System VCM-X/RNE Operator Interfaces - Manual (Page 14)

Zone
Zone
INITIALIZATION
VCM-X / RNE Operator Interfaces Technical Guide 14
Modular Service Tool Override Search
When a space sensor with override option is used with any VAV/Zone
VCM-X, or RNE Controller, the Modular Service Tool can determine
and report any controllers that are currently operating in an override
condition on the local loop whose ID (Address) has been entered be-
fore running the search. This function requires that a MiniLink Polling
Device is installed on each loop where the controllers may be located.
To access the Overrides Screen, press
<OVERRIDES>
from the
Modular Service Tool’s keypad. A screen will appear asking you to
enter a unit ID. Enter an ID for any active controller on the local loop
you wish to search and press
<ENTER> . Unlike the System Manager,
only the overrides on this loop will be searched, not the entire system.
The following screen will appear:
Overrides Screen
SEARCHING!
After the Service Tool completes its search, it will list the fi rst unit on
the selected local loop that is currently in the override mode. Press the
previous or next button to scroll through all units on the local loop you
have selected that are in the Override Mode.
Overrides Screen
Loop = 1 Unit = 59
Override Unit
Setting the Energy Saving Timer
The Modular Service Tool has a built-in timer that can be programmed
to shut the Service Tool off after a specifi ed period of time if no but-
tons are pressed. This is a very useful feature if you are powering the
Service Tool from the internal batteries. To access this setting from the
Main Status Screen, press
<ENTER>
. The following screen will appear:
1) Set Time & Date
2) Communications
3) Energy Saving
ESC) Exit Menu
Press
<3>
to access the Energy Saving Screen. The following screen
will appear:
Energy Saving
Automatic Power Down
Minutes: xx
Press ESC to Exit
Enter the number of minutes you want the Service Tool to stay active
before it automatically powers down. To cancel the automatic power
down, enter
<99>
. After you have entered a number between 1 and 99
minutes, press
<ESC>
to exit the screen.
Modular Service Tool Initialization