Orion System VCM-X/RNE Operator Interfaces - Manual (Page 57)

VCM-X / RNE STATUS
VCM-X / RNE Operator Interfaces Technical Guide 57
Status Screens 26-32 - Supply Fan Relay
VCM-X / RNE v1.00
Fan Relay: OFF
Cool Stage 1: OFF
Heat Stage 1: OFF
Line 2 Current Supply Fan Relay Status
The letters FRC will appear before the colon if this Relay is
in a Force Mode. On screens 24 to 30, this line will indicate
the relays use and the ON/OFF condition for that relay.
Possible options are as follows:
Not Used Pre-Heater
Heat Stage Alarm Relay
Cool Stage Override
Warmup Mode Occupied
Rev Valve Economizer (OA Damper)
Gas Re-Heat ( HGR Relay) Heat Wheel
Exhaust Fan Emergency Heat
Line 3 Current relay status and description of what it is
confi gured for
The letters FRC will indicate the relay is forced to its
current condition.
Line 4 Current relay status and description of what it is
confi gured for
The letters FRC will indicate the relay is forced to its
current condition.
Status Screen 33 - Alarm Conditions
VCM-X / RNE v1.00
NO ALARMS
Line 2 Blank
Line 3 Alarm Conditions
Can be one of the following:
NO SUPPLY AIR TEMP
NO OUTDOOR AIR TEMP
SPACE SENSOR FAILURE
MECH COOLING FAILURE
MECH HEATING FAILURE
FAN PROVING ALARM
DIRTY FILTER ALARM
EMERGENCY SHUTDOWN
LO SUPPLY AIR ALARM
HI SUPPLY AIR ALARM
LOW CONTROL TEMP
HIGH CONTROL TEMP
MODULE ALARM
If you press <ENTER> , the screen will scroll through
all active alarms.
For Alarm Defi nitions, see the VCM-X Controller
Technical Guide, the VCM-X Modular E-BUS Controller
Technical Guide, or the RNE Controller Technical Guide.
VCM-X / RNE Status Screens