Orion System VCM-X/RNE Operator Interfaces - Manual (Page 17)

VCM-X / RNE Operator Interfaces Technical Guide
INITIALIZATION
17
Holiday Start/Stop Times
VCM-X / RNE Hldy
Holiday Schedule
Start Event #1: XXXX
Stop Event #1: XXXX
VCM-X / RNE Hldy
Holiday Schedule
Start Event #2: XXXX
Stop Event #2: XXXX
The fourteen holidays all use the same Start and Stop times which you
program on this screen and the next. You must enter the time in 24-hour
military format, the same as a regular week schedule.
Normally, the holidays will operate in an unoccupied mode or a reduced
schedule mode. There are two start/stop events available on holidays to
match the standard schedule number of events.
Holiday Scheduling and Schedule Override
Schedule Override
VCM-X / RNE Ovrd
Schedule Override
Enter Override...: X
[0=Auto 1=ON 2=OFF]
If you want to force the unit to operate in a continuous Occupied or
Unoccupied mode, select this menu item to activate the desired method.
If a Schedule Override is active, all other methods of schedule control
are ignored (Push-Button, Internal, and Remote).
As you can see on the last line of the display, enter
<1>
to run continu-
ously in the Occupied Mode or
<2>
to run continuously in the Unoc-
cupied Mode. To restore normal schedule operations, enter <0> .
This override remains in effect until canceled and does not time-out like
the Output Overrides do after 10 minutes of no communications.
NOTE: Do not use the Force OFF mode in place of setting all
the week schedules to ZERO if you are using a Remote
Signal for your scheduling since the Override has priority
over the Remote Signal.