Troubleshooting, Led indicator details – Canon REALiS 4K501ST Pro AV 5000-Lumen LCoS Projector User Manual
Page 187
187
O
ther Information
T
rou
blesho
oting
Troubleshooting
LED Indicator Details
When there is a problem with the projector, the LED indicator on the side of the
projector illuminates or flashes continuously after the projector is turned off.
• Wait until the cooling fan stops and disconnect the power plug from the electrical outlet before
dealing with the problem.
LED indicator
status
Meaning
Cause and countermeasure
WARNING and
TEMP are lit.
Temperature
abnormality
The temperature inside the projector is too high for
some reason or the outside air temperature is
higher than the operating range. If the problem is
inside the projector, check whether the projector is
installed and operating normally, unplug the
projector from the power outlet to cool down the
projector interior and then restart projection. If the
air intake or exhaust vent is blocked, remove the
obstacle. If the air filter is clogged, clean or replace
it. (
) If the same warning occurs again,
there may be a malfunction in the projector.
Contact the Canon Customer Support Center.
WARNING and
LAMP are lit.
Faulty lamp
The lamp does not illuminate. If the lamp does
not illuminate, replace it. If the same warning
occurs again, there may be a malfunction in the
lamp drive circuit. Contact the Canon Customer
Support Center.
WARNING
(only) flashes
3 times
repeatedly.
Filter error
The air filter is not installed. Check whether or not
the air filter is installed correctly. Contact the
Canon Customer Support Center if the same
warning occurs again.
WARNING
flashes 3 times,
LAMP is lit.
Faulty lamp
cover
The lamp cover is open. Unplug the projector
from the power outlet, then install the lamp cover
correctly and turn on the projector again.
If the lamp cover has been installed properly,
there may be a malfunction in the lamp cover
detection switch. Contact the Canon Customer
Support Center.
WARNING
(only) flashes
4 times
repeatedly.
Faulty
cooling fan
There may be a malfunction in the cooling fan or
another component. Unplug the projector from
the electrical outlet, then plug it back into the
outlet and turn on the projector again. Contact
the Canon Customer Support Center if the same
warning occurs again.