Canon REALiS 4K501ST Pro AV 5000-Lumen LCoS Projector - Manual (Page 79)

Projection Procedure
79
Basic
Guide
Pr
oje
cti
on
Pr
oc
ed
u
re
Step 7 Turn the Projector Off
1
Press the POWER button to display the window shown below.
2
When this window is displayed, press the POWER button again to turn off
the power.
After you turn the projector off, the lamp goes off, the [STAND BY] indicator
flashes in red, and the projector starts cooling down. After cooling down, the
projector enters standby mode. In standby mode, the [STAND BY] indicator
remains lit instead of flashing.
If you want to continue projecting without turning off the power, press a button
other than
POWER , or else wait until the confirmation message disappears.
• The projector cannot be turned on while the lamp is cooling down.
• After turning off the projector, wait at least 5 minutes before turning it on again. It may
shorten the lamp life if you turn on the projector immediately after turning it off.
• Using the projector for extended periods may shorten the life of the lamp and internal
optical components.
• Unplug the projector if it will not be used for an extended period.
Remote control Projector