FUJITSU SOFTUNE F2 MC-16 - Manual (Page 137)

123
CHAPTER 2 DEPENDENCE FUNCTIONS
2.2.9.1 Performance Measurement Procedures
Performance can be measured by the following procedure:
• Setting event mode.
• Setting minimum measurement unit for timer.
• Specify performance-buffer-full break.
• Setting events.
• Execute program.
• Display measurement result.
• Clear measurement result.
■
Setting Event Mode
Set the event mode to the performance mode using the SET MODE command. This enables the performance
measurement function.
[Example]
>SET MODE/PERFORMANCE
>
■
Setting Minimum Measurement Unit for Timer
Using the SET TIMESCALE command, choose either 1
μs or 100 ns as the minimum measurement unit for
the timer used to measure performance. The default is 1
μs.
When the minimum measurement unit is changed, the performance measurement values are cleared.
[Example]
>SET TIMERSCALE/1U <- Set 1
μ
s as minimum unit.
>
■
Specify Performance-Buffer-Full Break
When the buffer for storing performance measurement data becomes full, a executing program can be
broken. This function is called the performance-buffer-full break. The performance buffer becomes full when
an event occurs 32767 times.
If the performance-buffer-full break is not specified, the performance measurement ends, but the program
does not break.
[Example]
>SET PERFORMANCE/NOBREAK <- Specifying Not Break
>