1 resources used by monitor program, Resources used by monitor program – FUJITSU SOFTUNE F2 MC-16 User Manual
Page 338
324
CHAPTER 2 DEPENDENCE FUNCTIONS
2.7.1
Resources Used by Monitor Program
The monitor program of the monitor debugger uses the I/O resources listed below. The
target hardware must have these resources available for the monitor program.
■
Required Resources
The following resources are required to build the monitor program into the target hardware.
Table 2.7-1 Resources Used by Monitor Debugger
1 UART
Necessary
For
communication with host computer
4800/9600/19200/38400 bps
2
Monitor ROM
Necessary
Need about 10 KB (For details, refer to link map.)
3
Work RAM
Necessary
Need about 2 KB (For details, refer to link map.)
4
External-interrupt switch
Option
Uses for forced abortion of program. When the
switch is not built-in, the program can stop at the
breakpoint only.
5
Timer
Option
Uses for SET TIMER/SHOW TIMER . Needs 32 bits
in 1
μs units.