FUJITSU SOFTUNE F2 MC-16 - Manual (Page 155)

141
CHAPTER 2 DEPENDENCE FUNCTIONS
2.3.1.3 Debug Area
Set the intensive debugging area out of the whole memory space. The area functions are
enhanced.
■
Setting Debug Area
There are two debug areas: DEBUG3, and DEBUG4. A continuous 1 MB area (16 banks) is set for each area.
Set the debug area using the SET DEBUG command.
Setting the debug area enhances the coverage measurement function.
- Enhancement of Coverage Measurement Function
Setting the debug area enables the coverage measurement function. In coverage measurement, the
measurement range can be specified only within the area specified as the debug area. In 00 to 0F bank and
0F0 to 0FF bank, a breakpoint can be set without specifying the debug area. (DEBUG1, DEBUG2)