FUJITSU SOFTUNE F2 MC-16 - Manual (Page 317)

303
CHAPTER 2 DEPENDENCE FUNCTIONS
Notes:
• When the pass count mode is a passing count break mode, this function cannot be used.
For details, refer to "2.6.3.2 Switching Debug Function".
• Depending on the output timing of external trace data, the actual order of code execution may
change places with the order of data hit information. For this reason, if a code event and a data
event occur close to each other, normal transition may not occur.
• A sequencer shares points with the following functions. The maximum number varies depending on
how those functions are used.
- Code break
- Data break
- Data watch break
• If a data event is set to the sequencer, the data event may stop after a few instructions following the
instruction with detection access are executed.
• If an event of the sequencer is set to the string instruction, the sequencer may not operate as
expected by the following reason.
- In code event
The pass count may be added several times by one instruction execution.
- In data event
A data access in the string instruction is optimized in the chip.