FUJITSU SOFTUNE F2 MC-16 - Manual (Page 54)

40
CHAPTER 2 DEPENDENCE FUNCTIONS
2.1.6 Reset Simulation
This section describes the reset simulation executed by SOFTUNE Workbench.
■
Reset Simulation
The simulator debugger simulates the operation when a reset signal is input to the MCU using the [Debug]-
[Reset MCU] menu and initializes the registers. The function for performing reset processing by operation of
MCU instructions (writing to RST bit in standby control register) is also supported. In this case, the reset
message (Reset) is displayed on the status bar.