FUJITSU SOFTUNE F2 MC-16 - Manual (Page 265)

251
CHAPTER 2 DEPENDENCE FUNCTIONS
2.5.4.8 Forced Break
It is a function to abort the execution of the program compulsorily.
■
Forced Break
It is a function to abort the execution of the program compulsorily.
When a break occurs due to a forced break, the following message is displayed on the Status Bar.
Break at Address by command abort request
Note:
A forced break is not allowed while the MCU is in the low-power consumption mode or hold state.
When a forced break is requested by the [Debug] - [Abort] menu while executing a program, the menu
is disregarded if the MCU is in the low-power consumption mode or hold state. If a break must occur,
then reset the cause at user system side, or reset the cause by using the [Debug] - [Reset MCU]menu,
after inputting the [Debug] - [Abort] menu.
When the MCU enters the power-save consumption mode or hold state while executing, the status is
displayed on the Status Bar.