FUJITSU SOFTUNE F2 MC-16 - Manual (Page 161)

147
CHAPTER 2 DEPENDENCE FUNCTIONS
2.3.1.7 Event Mode
There are three event modes as listed below.
• Normal mode
• Multi trace mode
• Performance mode
■
Event Mode
Event mode is used to determine which function the event triggers are used for. To set the mode, use [Event]
tab on [Setup] - [Debug Environment] - [Debug Environment] menu or the SET MODE command on the
command window. The default is normal mode.
There are three event modes as listed below.
• Normal mode
Event triggers are used for the single trace.
• Multi trace mode
Event triggers are used for the multi trace (trace function which samples data before and after the event
trigger occurred).
• Performance mode
Event triggers are used for the performance measurement. It enables to measure time duration between
two event trigger occurrence and count of event trigger occurrence.
Note:
The multi trace mode can be specified only when the debug function on MB2147-01 is set to Trace
Enhancement mode. For more details, see Section "2.3.1.6 Debug Function".