Siemens S223 - Manual (Page 154)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
154 A50010-Y3-C150-2-7619
execution of command, apply. That is, if several rules being different only in one
value should be created, then only the one changed value needs to be entered again.
7.6.4.6 Modifying and Deleting Rule
To modify a rule, use the following command.
Command Mode Description
rule NAME modify admin Global Modifies an admin access rule, enter a rule name.
To delete a rule, use the following command.
Command Mode Description
no rule admin
Deletes an admin access rule, enter a rule name op-
tionally.
no rule all
Global
Deletes all rules and admin access rules.
7.6.4.7 Displaying Rule
The following command can be used to show a certain rule by its name, all rules of a cer-
tain type, or all rules at once sorted by rule type.
Command Mode Description
show rule admin Shows all admin access rules sorted by type.
show rule all Shows all rules and admin access rules sorted by type.
show rule statistics
Enable
Global
Shows rule statistics.
show rule-profile Admin-rule Shows a current configuration of a rule.