Siemens S223 - Manual (Page 162)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
162 A50010-Y3-C150-2-7619
To remove registered dynamic MAC addresses from the MAC table, use the following
command.
Command Mode Description
clear mac Clears dynamic MAC addresses.
clear mac NAME Clears dynamic MAC addresses.
clear mac NAME PORT
Clears dynamic MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.
clear mac NAME PORT
MACADDR
Enable
Global
Bridge
Clears dynamic MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.
To remove static MAC addresses manually registered by user from the MAC table, use
the following command.
Command Mode Description
no mac Deletes static MAC addresses.
no mac NAME Deletes static MAC addresses, enter the bridge name.
no mac NAME PORT
Deletes static MAC addresses.
NAME: enter the bridge name.
PORT: enter the port number.
no mac NAME PORT MACADDR
Bridge
Deletes a specified static MAC address.
NAME: enter the bridge name.
PORT: enter the port number.
MACADDR: enter the MAC address.
To display a MAC table in the switch, use the following command.
Command Mode Description
show mac NAME [PORT]
Enable
Global
Bridge
Shows switch MAC address, selection by port number
(subscriber port only):
NAME: enter the bridge name
PORT: select the port number.
There are more than a thousand of MAC addresses in MAC table. And it is difficult to find
information you need at one sight. So, the system shows certain amount of addresses
displaying –more– on standby status. Press any key to search more. After you find the in-
formation, you can go back to the system prompt without displaying the other table by
pressing <q>.
i