Siemens S223 User Manual
Page 273
User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 273
open Interface configuration mode of VLAN to register as a switch group for stacking.
The following is an example of configuring Interface of switch group as 1.
SWITCH_A# configure terminal
SWITCH_A(config)# interface 1
SWITCH_A(interface)# ip address 192.168.10.1/16
SWITCH_A(interface)# no shutdown
SWITCH_A(interface)#
If there are several switches, rest of them are managed by a single IP address of Master
switch. Therefore you don’t need to configure IP address in Slave switch.
Step 2
Configure Switch A as Master switch. Configure VLAN to belong in the same switch group
after registering Slave switch, configure it as a Master switch.
<Switch A – Master Switch>
SWITCH_A(config)# stack master
SWITCH_A(config)# stack device default
SWITCH_A(config)# stack add 00:d0:cb:22:00:11
Step 3
Configure VLAN in order to belong to the same switch group in Switch B registered by
Master switch as Slave switch and configure as a Slave switch.
<Switch B – Slave Switch>
SWITCH_B(config)# stack slave
SWITCH_B(config)# stack device default
Step 4
Check the configuration. The information you can check in Master switch and Slave
switch is different as below.
<Switch A – Master Switch>
SWITCH_A(config)# show stack
device : default
node ID : 1
node MAC address status type name port
1 00:d0:cb:0a:00:aa active SURPASS hiD 6615 S223/S323 SWITCH_A 24
2 00:d0:cb:22:00:11 active SURPASS hiD 6615 S223/S323 SWITCH_B 24
SWITCH_A(config)#
<Switch B – Slave Switch>
SWITCH_B(config)# show stack
device : default
node ID : 2
SWITCH_B(config)#
i