Siemens S223 - Manual (Page 366)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
366 A50010-Y3-C150-2-7619
Command Mode Description
match interface INTERFACE
Transmits the information to specified interface only.
INTERFACE: interface name
match ip address {<1-199> |
<1300-2699> | NAME}
Transmits the information matched with access-list.
1-199: IP access list number
1300-2699: IP access list number (expanded range)
NAME: IP access list name
match ip address prefix-list
NAME
Transmits the information matched with prefix-list.
NAME: IP prefix list name
match ip next-hop {<1-199> |
<1300-2699> | NAME}
Transmits information to only neighbor router in ac-
cess-list.
1-199: IP access list number
1300-2699: IP access list number (expanded range)
NAME: IP access list name
match ip next-hop prefix-list
NAME
Route-map
Transmits information to only neighbor router in prefix-
list.
NAME: IP prefix list name
Command Mode Description
match metric <0-4294967295>
Transmits information matched with specified metric,
enter the metric value.
set ip next-hop A.B.C.D
Configures Neighbor router’s address.
A.B.C.D: IP address of next hop
set metric <1-2147483647>
Route-map
Sets the metric value for destination routing protocol.
1-2147483647: metric value
10.3.6 Metrics for Redistributed Routes
The metrics of one routing protocol do not necessarily translate into the metrics of another.
For example, the RIP metric is a hop count and the OSPF metric is a combination of five
quantities. In such situations, an artificial metric is assigned to the redistributed route. Be-
cause of this unavoidable tampering with dynamic information, carelessly exchanging
routing information between different routing protocols can create routing loops, which
can seriously degrade network operation. To prevent this situation, we configure metrics
To set metrics for redistributed routes, use the following command.
Command Mode Description
default-metric <1-16>
Configures the equal metric of all routes transmitted by
routing protocol, enter the value.
1-16: default metric value
no default-metric [<1-16>]
Router
Removes the equal metric of all routes transmitted by
routing protocol.
The metric of all protocol can be configured from 0 to 4294967295. It can be configured
from 1 to 16 for RIP.
i