Siemens S223 - Manual (Page 55)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 55
4.2.8 Sample Configuration
[Sample Configuration 1] Configuration RADIUS server
The following is an example of configuring authorization method in SURPASS hiD 6615. It
is configured to add RADIUS to default method in case of clients connecting through con-
sole and telnet. And, the priority is given to RADIUS in case of clients connecting through
console and to default method in case of clients connecting through telnet.
Then, show the configuration. And The following is an example of configuring frequency
of retransmit and timeout of response after registering RADIUS server.
SWITCH(config)# user add user test1
Changing password for user
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:vertex
Re-enter new password:vertex
Password changed.
SWITCH(config)# login local radius enable
SWITCH(config)# login remote radius enable
SWITCH(config)# login local radius primary
SWITCH(config)# login remote host primary
SWITCH(config)# login radius server add 100.1.1.1 1
SWITCH(config)# login radius retransmit 5
SWITCH(config)# login radius timeout 10
SWITCH(config)# show login
[AUTHEN]
Local login : radius host
Remote login : host radius
Accounting mode : both
------------------------------------
[HOST]
maximum_login_counts : 8
------------------------------------
[RADIUS]
<Radius Servers & Key>
100.1.1.1 1
Radius Retries : 5
Radius Timeout : 10
Radius Interface : default
------------------------------------
[TACACS]
<Tacacs Servers & Key>
Tacacs Timeout : 3
Tacacs Socket Port : 49
Tacacs Interface : default
Tacacs PPP Id : 1
Tacacs Authen Type : ASCII
Tacacs Priority Level : MIN
SWITCH(config)#
Displayed according to priority.