Siemens S223 - Manual (Page 309)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 309
decide which IP address to be used as candidate-RP. This command is used to statically
configure the RP address for multicast groups.
To configure IP address to be used in candidate-RP, use the following command.
Command Mode Description
ip pim rp-address A.B.C.D [<1-
99> | <1300-1999>] [override]
Global
Configures RP address for multicast groups statically.
A.B.C.D: IP address
1-99: IP standard access list
1300-1999: IP standard access list (expanded range)
override: override dynamically RP mappings
• If RP-address configured through BSR and RP-address configured statically are both
available for a group range, the RP-address configured through BSR is chosen.
• If multiple static-RPs are available for a group range, then one with the highest IP
address is chosen.
To delete configured IP address, use the following command.
Command Mode Description
no ip pim rp-address A.B.C.D Global Deletes configured IP address.
9.3.4.2 Enabling Transmission of Candidate RP Message
Use this command to give the router the candidate RP status using the IP address of the
specified interface.
Command Mode Description
ip pim rp-candidate INTERFACE
[group-list <1-99>] [interval <1-
16383>] [priority <0-255>] Global
Configures a message for a candidate RP.
INTERFACE: interface name
1-99: IP standard access list
1-16383: advertisement interval (unit: second)
0-255: priority value
To delete configured priority of candidate-RP, use the following command.
Command Mode Description
no ip pim rp-candidate Unconfigures the entire setting of candidate-RP.
no ip pim rp-candidate
INTERFACE
no ip pim rp-candidate
INTERFACE group-list <1-99>
Global
Deletes the setting of candidate-RP of specific inter-
face.