Siemens S223 - Manual (Page 294)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
294 A50010-Y3-C150-2-7619
9.2.5.4 IGMP v2 Snooping Report Method
When IGMP report suppression is enabled, the switch forwards only one IGMP report per
multicast router query. When report suppression is disabled, all IGMP reports are for-
warded to the multicast routers.
Command Mode Description
ip igmp snooping report-
suppression
Configures the IGMP report suppression on the sys-
tem.
ip igmp snooping vlan VLANS
report-suppression
Global
Configures the IGMP report suppression on a VLAN
interface.
IGMP report suppression is supported only when the multicast query has IGMP v1 and
IGMP v2 reports. This feature is not supported when the query includes IGMP v3 reports.
To disable IGMP snooping report suppression, use the following command.
Command Mode Description
no ip igmp snooping report-
suppression
Deletes the IGMP report suppression on the system.
no ip igmp snooping vlan
VLANS report-suppression
Global
Deletes the IGMP report suppression on a VLAN inter-
face.
To display the IGMP Report Suppression configuration, use the following command.
Command Mode Description
show ip igmp snooping [vlan
VLANS ]
Enable
Global
Bridge Shows that the IGMP report suppression is enabled
9.2.5.5 Mrouter Port
Configuring Mrouter Port per VLAN
You can designate, to which port, the multicast router is connected. If you designate mul-
ticast router is connected to where, it is possible to transmit multicast packet or message
only to that port.
To designate the port connected to multicast router, use the following command.
Command Mode Description
ip igmp snooping mrouter port
{PORTS | cpu}
Designates the port where multicast router is con-
nected to on the system.
PORTS: logical port number ID to use
cpu: identifies the CPU port to use.
ip igmp snooping vlan VLANS
mrouter port {PORTS | cpu}
Global
Designates the port where multicast router is con-
nected to on a VLAN interface.