Siemens S223 - Manual (Page 237)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 237
8.6.2 Sample Configuration
The following is an example of showing the configuration after limiting the number of
packets transmitted to the port number 1 as 10,000.
SWITCH(bridge)# mac-flood-guard 1 10000
SWITCH(bridge)# show mac-flood-guard
---------------------------------
Port Rate(fps) | Port Rate(fps)
----------------+----------------
1 10000 | 2 Unlimited
3 Unlimited | 4 Unlimited
5 Unlimited | 6 Unlimited
7 Unlimited | 8 Unlimited
9 Unlimited | 10 Unlimited
11 Unlimited | 12 Unlimited
13 Unlimited | 14 Unlimited
15 Unlimited | 16 Unlimited
(Omitted)
SWITCH(bridge)#
8.7 Bandwidth
Routing protocol uses bandwidth information to measure routing distance value. To con-
figure bandwidth of interface, use the following command.
Command Mode Description
bandwidth BANDWIDTH Interface
Configures bandwidth of interface, enter the value of
bandwidth.
The bandwidth can be from 1 to 10,000,000 Kbits. This bandwidth is for routing informa-
tion implement and it does not concern physical bandwidth.
To delete a configured bandwidth, use the following command.
Command Mode Description
no bandwidth BANDWIDTH Interface
Deletes configured bandwidth of interface, enter the
value.
The following is an example of configuration to bandwidth as 1000.
SWITCH(config-if)# bandwidth 1000
SWITCH(config-if)# show running-config interface 1
!
interface default
bandwidth 1m
ip address 10.27.41.181/24
!
SWITCH(config-if)#
i