Siemens S223 - Manual (Page 194)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
194 A50010-Y3-C150-2-7619
enter. It is decided with Source IP address, Destination IP address, Source MAC address,
Destination Mac address and the user could get information of packets to decided packet
route.
• dstip : Destination IP address
• dstmac: Destination MAC address
• srcdstip: Refer to both Source IP address and Destination IP address
• srcdstmac: Refer to both Source MAC address and Destination MAC address
• srcip: Source IP address
• srcmac: Source MAC address.
The port designated as member port of port trunk is automatically deleted from existing
VLAN. Therefore, if member port and aggregated port exist in other VLAN, VLAN configu-
ration should be changed for the aggregated port.
8.2.1.2 Disabling Port Trunk
To remove the configured port trunk from specified trunk group, use the following com-
mand.
Command Mode Description
no trunk <0-5> PORTS
no trunk distmode <0-5>
Bridge Releases a configured trunk port.
If the user deleted member port from logical port or release port trunk, they are automati-
cally contained as default VLAN.
8.2.1.3 Displaying Port Trunk Configuration
To display a configuration of port trunk, use the following command.
Command Mode Description
show trunk
Enable
Global
Bridge Shows a configuration for trunk.
8.2.2 Link Aggregation Control Protocol (LACP)
Link Aggregation Control Protocol (LACP) is the function of using wider bandwidth by ag-
gregating more than two ports as a logical port as previously stated port trunk function. If
the integrated port by configuring from port trunk is in other VLAN which is different from
VLAN where existing member port is originally belong to, it should be moved to VLAN
where the existing member port is belong to. However, the integrated port configured by
LACP is automatically added to appropriate VLAN.
The LACP aggregator from LACP could support up to 14 so that it is possible to input ag-
gregator number from 0 to 13, and group ID of port trunk and aggregator number of LACP
cannot be configured repeatedly.
The following explains how to configure LACP.
i
i