Siemens S223 - Manual (Page 197)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 197
8.2.2.4 Identifying Member Ports within LACP
The port configured as member port is basically configured to aggregate to LACP. How-
ever, even though the configuration as member port is not released, they could operate
as independent port without being aggregated to LACP. These independent ports cannot
be configured as trunk port because they are independent from being aggregated to
LACP under the condition of being configured as member port.
To configure member port to aggregate to LACP, use the following command.
Command Mode Description
lacp port aggregation PORTS
{aggregatable | individual}
Bridge
Designates whether a member port joins LACP or not,
select the member port should be included. (default:
aggregatable)
To clear aggregated to LACP of configured member port, use the following command.
Command Mode Description
no lacp port aggregation PORTS Bridge
Deletes the configured member port in LACP, select
the member port.
8.2.2.5 BPDU Transmission Rate
Member port transmits BPDU with its information. For the hiD 6615 S223/S323, it is pos-
sible to configure the BPDU transmission rate, use the following command.
Command Mode Description
lacp port timeout PORTS {short |
long }
Bridge
Configures BPDU transmission rate:
PORTS: select the port number.
short: fast rate (once every 1 sec)
long: slow rate (30 sec: default)
To clear BPDU transmission rate, use the following command (clear means long timeout).
Command Mode Description
no lacp port timeout PORTS Bridge
Deletes BPDU transmission rate of configured member
port, select the port number.
8.2.2.6 Key value of Member Port
Member port of LACP has key value. All member ports in one aggregator have same key
values. To make an aggregator consisted of specified member ports, configure different
key value with key value of another port.
Command Mode Description
lacp port admin-key PORTS <1-
15>
Bridge
Configures key value of member port:
PORTS: select the port number.
1-15: select the port key value. (default: 1)