Siemens S223 - Manual (Page 91)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 91
6.1.14 Assigning IP Address of FTP Client
Serveral IP addresses can be assigned on hiD 6615 S223/S323. But user can specify
one source IP address connecting FTP server when the switch is a client. To configure
FTP binding address as a source IP address when hiD 6615 S223/S323 as a client con-
nects to FTP server, use the following command.
Command Mode Description
ftp bind-address A.B.C.D
Binds a source IP address for connecting to FTP
server..
no ftp bind-address
Global
Deletes FTP bind-address
Please be careful that the FTP bind-address is also applied to TFTP server’s bind-
address.
6.2 Configuration Management
You can verify if the system configurations are correct and save them in the system. This
section contains the following functions.
• Displaying System Configuration
• Saving System Configuration
• Auto-Saving
• System Configuration File
• Restoring Default Configuration
6.2.1 Displaying System Configuration
To display a current running configuration of the system, use the following command.
Command Mode Description
show running-config Shows a configuration of the system.
show running-config {admin-
rule | arp | bridge | dns | full |
hostname | instance | interface
INTERFACE I login | pm | qos |
rmon-alarm | rmon-event | rmon-
history | router {bgp | pim | rip |
ospf | vrrp} | rule | snmp | syslog
| time-out | time-zone | time-out}
Shows a configuration of the system with the specific
option.
show running-config router
{bgp | ospf | pim | rip | vrrp}
All
Shows only the configuration that corresponds to each
option.
i