Siemens S223 - Manual (Page 195)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 195
• Configuring LACP
• Packet Route
• Operating Mode of Member Port
• Priority of Switch
• Identifying Member Ports within LACP
• BPDU Transmission Rate
• Key value of Member Port
• Priority
• Displaying LACP Configuration
8.2.2.1 Configuring LACP
Step 1
Activate LACP function, using the following command.
Command Mode Description
lacp aggregator
AGGREGATIONS
Enables LACP of designated Aggregator-number:
AGGREGATIONS: select aggregator ID that should be
enabled for LACP (valid value from 0 to 13).
no lacp aggregator
AGGREGATIONS
Bridge
Disables LACP for designated Aggregator-number,
select the aggregator ID that should be disabled for
LACP.
Step 2
Configure the physical port that is a member of aggregated port. In order to configure the
member port, use the following command.
Command Mode Description
lacp port PORTS
Configures physical port that is member port of aggre-
gator; select the port number(s) that should be enabled
for LACP.
no lacp port PORTS
Bridge
Deletes member port of Aggregator, select the port
number(s) that should be disabled for LACP.
8.2.2.2 Packet Route
When packets enter to logical port integrating several ports, if there’s no process to de-
cide the packet route, it is not possible to use logical port effectively from focusing pack-
ets on a particular member port.
If these packets enter to logical port aggregating several ports and there’s no way to de-
cide packet route, the packets could be gathered on particular member port so that it is
not possible to use logical port effectively.
Therefore the hiD 6615 S223/S323 is configured to decide the way of packet route in or-
der to divide on member port effectively when packets are transmitted. It can be selected
with Source IP address, destination IP address, source MAC address, destination MAC
address and the user could get the information of packets to decided packet route.