Siemens S223 - Manual (Page 196)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
196 A50010-Y3-C150-2-7619
• dstip : Destination IP address
• dstmac: Destination MAC address
• srcdstip: Runs by reference to both Source IP address and Destination IP address
• srcdstmac: Source MAC address and Destination MAC address
• srcip: Source IP address
• srcmac: Source MAC address.
For the hiD 6615 S223/S323, srcdstmac (source MAC address and destination MAC ad-
dress) is basically used to decide packet route.
After configuring aggregator, you should configure packets transmitting aggregator port.
The following is the command of configuring packets transmitting aggregator port.
Command Mode Description
lacp aggregator distmode AG-
GREGETIONS {srcmac | dstmac
| srcdstmac | srcip | dstip |
srcdstip }
Bridge
Defines packets transmitted by way of aggregator
which is a logical aggregated port:
AGGREGATIONS: select the aggregator ID <0-13>.
To disable configuring packets, use the following command.
Command Mode Description
no lacp aggregator
AGGREGETIONS
Bridge
Deletes destination MAC address, select the aggrega-
tor ID.
8.2.2.3 Operating Mode of Member Port
After configuring member port, configure the mode of member port. There are two kinds
of mode Active mode and Passive mode in member port. The port of Passive mode starts
LACP when there’s Active mode on the port of opposite switch. The priority of Active
mode is higher that that of Passive mode so that the port of Passive mode follows the
port of Active mode.
If each member port of the connected switch is configured as Active mode and Passive
mode, Active mode is the standard. If both switches are configured as Passive mode, link
for member ports of two switches is not realized.
To configure the mode of member port, use the following command.
Command Mode Description
lacp port activity PORTS {active
| passive}
Bridge
Configure the mode of member port, select the mem-
ber port number. (default: active)
To delete an operating mode of configured member port, use the following command.
Command Mode Description
no lacp port activity PORTS Bridge
Deletes operation mode of configured member port,
select the member port number.
i
i