Siemens S223 - Manual (Page 368)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
368 A50010-Y3-C150-2-7619
10.3.9.1 Filtering Access List and Prefix List
The hiD 6615 S323 switch is able to permit and deny conditions that you can use to filter
inbound or outbound routes by access-list or prefix-list. Use the distribute-list command
to apply the access list to routes received from or forwarded to a neighbor.
User should configure the route information for a set of deny conditions based on match-
ing each access list or prefix list. In addition, this configuration is able to be applied on the
specific interface as well as the whole routes information of switch.
To block the route information based on matching access list or prefix list, use the follow-
ing command.
Command Mode Description
distribute-list ACCESS-LIST {in |
out } [INTERFACE]
distribute-list prefix PREFIX-
LIST {in | out} [INTERFACE]
Router
Apply a specific access list or prefix list to incoming or
outgoing RIP route updates on interface in order to
block the route.
INTERFACE: interface name
ACCESS-LIST: access list name
PREFIX-LIST: prefix list name
To remove the filtering access list or prefix-list to incoming or outgoing RIP route
Command Mode Description
no distribute-list ACCESS-LIST
{in | out} [INTERFACE]
no distribute-list prefix PREFIX-
LIST {in | out} [INTERFACE]
Router
Removes the application of a specific access list or
prefix list to incoming or outgoing RIP route updates on
interface in order to block the route.
10.3.9.2 Disabling the transmission to Interface
To prevent other routers on a local network from learning about routes dynamically, you
can keep routing update messages from being sent through a router interface. This fea-
ture applies to all IP-based routing protocols except for BGP.
Disable the routing information to transmit on this interface of router, use the following
command.
Command Mode Description
passive-interface INTERFACE
Disables the transmission of multicast RIP messages
on the interface.
INTERFACE: interface name
no passive-interface INTERFACE
Router
Re-enables the transmission of RIP multicast mes-
sages on the specified interface.
10.3.9.3 Offset List
An offset list is the mechanism for increasing incoming and outgoing metrics to routes
learned via RIP. You can limit the offset list with an access list.