Siemens S223 - Manual (Page 364)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
364 A50010-Y3-C150-2-7619
Command Mode Description
ip rip receive version 1 Receives RIP v1 type packet only from the interface.
ip rip receive version 2 Receives RIP v2 type packet only from the interface.
ip rip receive version 1 2
Interface
Receives both RIP v1 and RIP v2 type packets from
the interface.
To delete the configuration that receives RIP version packet from the interface, use the
following command.
Command Mode Description
no ip rip receive version 1
Deletes the configuration of RIP v1 type packet for
helping them be received from the interface.
no ip rip receive version 2
Deletes the configuration of RIP v2 type packet for
helping them to be received from interface.
no ip rip receive version 1 2
Interface
Deletes the configuration of both RIP v1 and RIP v2
type packets for helping them to be received from the
interface.
10.3.4 Creating available Static Route only for RIP
This feature is provided only by Siemens’ route command creates static route available
only for RIP. If you are not familiar with RIP protocol, you would better use redistribute
static
command.
Command Mode Description
route A.B.C.D/M
Creates suitable static route within RIP environment
only.
A.B.C.D/M: IP prefix
no route A.B.C.D/M
Router
Deletes this static route established by route com-
mand.
10.3.5 Redistributing Routing Information
The hiD 6615 S323 can redistribute the routing information from a source route entry into
the RIP tables. For example, you can instruct the router to re-advertise connected, kernel,
or static routes as well as other routes established by routing protocol. This capability ap-
plies to all the IP-based routing protocols.
To redistribute routing information from a source route entry into the RIP table, use the
following command.