Siemens S223 - Manual (Page 159)

User Manual UMN:CLI
SURPASS hiD 6615 S223/S323 R1.5
A50010-Y3-C150-2-7619 159
Step 2
Set the maximum number of secure MAC address for the port.
Command Mode Description
port security PORTS maximum
<1-16384>
Bridge
Sets a maximum number of secure MAC address for
the port.
1-16384: Maximum number of addresses (default: 1)
Step 3
Set the violation mode and the action to be taken.
Command Mode Description
port security PORTS violation
{shutdown | protect | restrict}
Bridge Selects a violation mode.
When configuring port security, note that the following information about port security vio-
lation modes:
•
protect drops packets with unknown source addresses until you remove a sufficient
number of secure MAC addresses to drop below the maximum value.
• restrict drops packets with unknown source addresses until you remove a sufficient
number of secure MAC addresses to drop below the maximum value and causes the
Security Violation counter to increment.
• shutdown puts the interface into the error-disabled state immediately and sends an
SNMP trap notification
Step 4
Enter a secure MAC address for the port.
Command Mode Description
port security PORTS mac-
address MACADDR vlan NAME
Bridge
Sets a secure MAC address for the port.
PORTS: select the port number.
MACADDR: enter the MAC address.
NAME: vlan name
To disable the configuration of port secure, use the following command.
Command Mode Description
no port security PORTS Disables port security on the port.
no port security PORTS mac-
address MACADDR vlan NAME
Deletes a secure MAC address for the port.
PORTS: enter the port number
MACADDR: enter the MAC address.
no port security PORTS maxi-
mum
Returns to the default number of secure MAC address.
(default: 1)
no port security PORTS viola-
tion
Bridge
Returns to the violation mode to the default. (shutdown
mode)