Siemens S223 - Manual (Page 90)

UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
90 A50010-Y3-C150-2-7619
6.1.12.4 System Temperature
To set a threshold of system temperature, use the following command.
Command Mode Description
threshold temp VALUE VALUE
Sets a threshold of system temperature in the unit of
centigrade (°C).
VALUE: Threshold temperature between -40 ~ 100
no threshold temp
Global
Deletes a configured threshold of system temperature.
To show a configured threshold of system temperature, use the following command.
Command Mode Description
show status temp
Enable
Global
Shows a status and configured threshold of system
temperature.
6.1.12.5 System Memory
To set a threshold of system memory in use, use the following command.
Command Mode Description
threshold memory <20-100>
Sets a threshold of system memory in the unit of per-
cent (%).
20-100: system memory in use
no threshold memory
Global
Deletes a configured threshold of system memory.
6.1.13 Enabling FTP Server
FTP server is enabled on hiD 6615 S223/S323 by default. But this configuration can’t
provide the security serveice becaue it’s easy to access to the port #23 by others. If the
default configuration is unnecessary on sysem, user can disable the system as FTP
server.
To enable/disable the system of hiD S223/S323 as FTP server, use the following com-
mand.
Command Mode Description
ftp server {enableㅣdisable} Global
Enables/ disables the function for FTP serve
Default: enable
The follwing is an example of displaying the status of FTP server.
SWITCH(config)# ftp server disable
SWITCH(config)# show running-config
(Omitted)
!
ftp server disable
(Omitted)
SWTICH(config)#