6 configuring port roles, Figure 66 dmz private and public address example – ZyXEL Communications ZyXEL ZyWALL 35 User Manual
Page 172
ZyWALL 35 User’s Guide
170
Chapter 8 DMZ Screens
Configure both DMZ and DMZ IP alias to use this kind of network setup. You also need to
configure NAT for the private DMZ IP addresses.
Figure 66 DMZ Private and Public Address Example
8.6 Configuring Port Roles
To configure a LAN/DMZ port as a LAN or DMZ port, select its radio button next to LAN or
DMZ and click Apply. Otherwise, click Reset to restore the previous configuration. The radio
buttons correspond to Ethernet ports on the front panel of the ZyWALL. By default, ports 1 to
4 are all LAN ports.
Click DMZ, then Port Roles. The screen appears as shown.
Note: Do the following if you are configuring from a computer
connected to a LAN or DMZ port and changing the port's role:
1. Make sure your computer's IP address is in the same subnet
as the ZyWALL's LAN or DMZ IP address.
2. A port's IP address varies as its role changes, use the
appropriate LAN or DMZ IP address to access the ZyWALL.