ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 459)

ZyWALL 35 User’s Guide
Chapter 32 Remote Node Setup 457
C
H A P T E R
32
Remote Node Setup
This chapter shows you how to configure a remote node.
32.1 Introduction to Remote Node Setup
A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.x (where x is 1 or 2) - Remote Node Profile,
Menu 11.x.2 - Remote Node Network Layer Options and Menu 11.x.4 - Remote Node
Filter.
32.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
Then enter 1 or 2 to open Menu 11.x - Remote Node Profile and configure the setup for your
first or second WAN port. Enter 3 to open Menu 11.3 Remote Node Profile (Backup ISP)
and configure the setup for your Dial Backup port connection (see
Chapter 27 WAN and Dial
Backup Setup ).
Figure 262 Menu 11: Remote Node Setup
32.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu.
Menu 11 - Remote Node Setup
1. WAN_1 (ISP, SUA)
2. WAN_2 (ISP, NAT)
3. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit: