ZyXEL Communications ZyXEL ZyWALL 35 User Manual

Page 441

Advertising
background image

ZyWALL 35 User’s Guide

Chapter 28 LAN Setup

439

Figure 246 Menu 3.2: TCP/IP and DHCP Ethernet Setup

Follow the instructions in the next table on how to configure the DHCP fields.

Use the instructions in the following table to configure TCP/IP parameters for the LAN port.

Menu 3.2 - TCP/IP and DHCP Ethernet Setup

DHCP= Server TCP/IP Setup:
Client IP Pool:
Starting Address= 192.168.1.33 IP Address= 192.168.1.1
Size of Client IP Pool= 128 IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
Edit IP Alias= No

DHCP Server Address= N/A

Press ENTER to Confirm or ESC to Cancel:

Table 162 Menu 3.2: DHCP Ethernet Setup Fields

FIELD

DESCRIPTION

DHCP

This field enables/disables the DHCP server.

If set to Server, your ZyWALL will act as a DHCP server.

If set to None, the DHCP server will be disabled.

If set to Relay, the ZyWALL acts as a surrogate DHCP server and relays requests

and responses between the remote server and the clients.
When set to Server, the following items need to be set:

Client IP Pool:

Starting Address

This field specifies the first of the contiguous addresses in the IP address pool.

Size of Client IP

Pool

This field specifies the size, or count of the IP address pool.

DHCP Server

Address

If Relay is selected in the DHCP field above, then type the IP address of the actual,

remote DHCP server here.

Note: LAN and DMZ IP addresses must be on separate
subnets.

Table 163 Menu 3.2: LAN TCP/IP Setup Fields

FIELD

DESCRIPTION

TCP/IP Setup:

IP Address

Enter the IP address of your ZyWALL in dotted decimal notation

Advertising