ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 319)

ZyWALL 35 User’s Guide
Chapter 18 Policy Route 317
The following table describes the labels in this screen.
18.5 Configuring the IP Policy Route Entry
Click the edit icon to open the screen as shown next.
Table 106 Policy Route Setup
LABEL DESCRIPTION
# This is the number of an individual policy route.
Active This field shows whether the policy is active or inactive.
Source Address/
Port
This is the source IP address range and/or port number range.
Destination
Address/Port
This is the destination IP address range and/or port number range.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Protocol This is the IP protocol and can be ICMP, UDP, TCP or ALL.
Action This field specifies whether action should be taken on criteria Matched or Not
Matched.
Modify Click the edit icon to go to the screen where you can edit the routing policy on the
ZyWALL.
Click the delete icon to remove an existing routing policy from the ZyWALL. A
window display asking you to confirm that you want to delete the address mapping
rule.
Move Type a policy route's index number and the number for where you want to put that
rule. Click Move to move the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their
numbering.