ZyXEL Communications ZyXEL ZyWALL 35 User Manual
Page 467

ZyWALL 35 User’s Guide
Chapter 32 Remote Node Setup
465
Use menu 11.1.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter
field. Note that spaces are accepted in this field. For more information on defining the filters,
please refer to
Chapter 36 Filter Configuration
. For PPPoE or PPTP encapsulation, you have
the additional option of specifying remote node call filter sets.
Figure 267 Menu 11.1.4: Remote Node Filter (Ethernet Encapsulation)
Figure 268 Menu 11.1.4: Remote Node Filter (PPPoE or PPTP Encapsulation)
Menu 11.1.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.1.4 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: