Figure 247 menu 3.2.1: ip alias setup, Table 164 menu 3.2.1: ip alias setup – ZyXEL Communications ZyXEL ZyWALL 35 User Manual

Page 443

Advertising
background image

ZyWALL 35 User’s Guide

Chapter 28 LAN Setup

441

Figure 247 Menu 3.2.1: IP Alias Setup

Use the instructions in the following table to configure IP alias parameters.

Menu 3.2.1 - IP Alias Setup

IP Alias 1= Yes
IP Address= 192.168.2.1
IP Subnet Mask= 255.255.255.0
RIP Direction= None
Version= RIP-1
Incoming protocol filters=
Outgoing protocol filters=
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A

Enter here to CONFIRM or ESC to CANCEL:

Table 164 Menu 3.2.1: IP Alias Setup

FIELD

DESCRIPTION

IP Alias 1, 2

Choose Yes to configure the LAN network for the ZyWALL.

IP Address

Enter the IP address of your ZyWALL in dotted decimal notation.

IP Subnet Mask

Your ZyWALL will automatically calculate the subnet mask based on the IP address

that you assign. Unless you are implementing subnetting, use the subnet mask

computed by the ZyWALL.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are

Both, In Only, Out Only or None.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are

RIP-1, RIP-2B or RIP-2M.

Incoming

Protocol Filters

Enter the filter set(s) you wish to apply to the incoming traffic between this node and

the ZyWALL.

Outgoing

Protocol Filters

Enter the filter set(s) you wish to apply to the outgoing traffic between this node and

the ZyWALL.

When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to

save your configuration, or press [ESC] at any time to cancel.

Advertising