ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 449)

ZyWALL 35 User’s Guide
Chapter 29 Internet Access 447
29.3 Configuring the PPTP Client
To configure a PPTP client, you must configure the My Login and Password fields for a PPP
connection and the PPTP parameters for a PPTP connection.
After configuring My Login and Password for PPP connection, press [SPACE BAR] and
then [ENTER] in the Encapsulation field in Menu 4 -Internet Access Setup to choose
PPTP as your encapsulation option. This brings up the following screen.
Figure 251 Internet Access Setup (PPTP)
The following table contains instructions about the new fields when you choose PPTP in the
Encapsulation field in menu 4.
29.4 Configuring the PPPoE Client
If you enable PPPoE in menu 4, you will see the next screen. For more information on PPPoE,
please see
Appendix D PPPoE .
Note: The ZyWALL supports only one PPTP server connection
at any given time.
Menu 4 - Internet Access Setup
ISP's Name= WAN_1
Encapsulation= PPTP
Service Type= N/A
My Login=
My Password= ********
Retype to Confirm= ********
Idle Timeout= 100
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address= N/A
Network Address Translation= SUA Only
Press ENTER to Confirm or ESC to Cancel:
Table 168 New Fields in Menu 4 (PPTP) Screen
FIELD DESCRIPTION
Encapsulation Press [SPACE BAR] and then press [ENTER] to choose PPTP. The encapsulation
method influences your choices for the IP Address field.
Idle Timeout This value specifies the time, in seconds, that elapses before the ZyWALL
automatically disconnects from the PPTP server.