ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 404)

ZyWALL 35 User’s Guide
402 Chapter 24 Maintenance
Figure 212 Device Mode (Router Mode)
The following table describes the labels in this screen.
When the ZyWALL is in bridge mode, the screen appears as shown next
Table 143 Device Mode (Router Mode)
LABEL DESCRIPTION
Current Device
Mode
Device Mode This displays whether the ZyWALL is functioning as a router or a bridge.
Device Mode Setup
Router When the ZyWALL is in router mode, there is no need to select or clear this radio
button.
IP Address Click LAN, WAN or DMZ to go to the LAN, WAN or DMZ screen where you can
view and/or change the corresponding settings.
Bridge Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
IP Address Enter the IP address of your ZyWALL in dotted decimal notation.
Subnet Mask Enter the IP subnet mask of the ZyWALL.
Gateway IP
Address
Enter the gateway IP address.
Apply Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Reset Click Reset to begin configuring this screen afresh.