ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 314)

ZyWALL 35 User’s Guide
312 Chapter 17 Static Route
17.2 Configuring IP Static Route
Click STATIC ROUTE to open the IP Static Route screen (some of the screen’s blank rows
are not shown).
Figure 152 IP Static Route
The following table describes the labels in this screen.
Note: The first two static route entries are for default WAN1 and
WAN2 routes and cannot be modified or deleted. The name of
each default static route is left blank unless you configure a
static WAN IP address.
The default route is disabled after you change the static WAN
IP address to a dynamic WAN IP address.
Table 104 IP Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Name This is the name that describes or identifies this route.
Active This field shows whether this static route is active (Yes) or not (No).