ZyXEL Communications ZyXEL ZyWALL 35 - Manual (Page 406)

ZyWALL 35 User’s Guide
404 Chapter 24 Maintenance
24.7 F/W Upload Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
"*.bin" extension, e.g., "zywall.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See
the Uploading Firmware and Configuration Files section for upgrading firmware using
FTP/TFTP commands.
Click MAINTENANCE, and then the F/W UPLOAD tab. Follow the instructions in this
screen to upload firmware to your ZyWALL.
Figure 214 Firmware Upload
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the LAN
Interface IP Address field to access the ZyWALL again.
Reset Click Reset to begin configuring this screen afresh.
Table 144 Device Mode (Bridge Mode) (continued)
LABEL DESCRIPTION
Table 145 Firmware Upload
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
Note: Do not turn off the ZyWALL while firmware upload is in
progress!